4 Accensione e spegnimanto di 2 LED.
5 Nel circuito oltre al LED montato direttamente sul pin 13
6 viene aggiunto un altro LED pilotato dal PIN 12.
8 Ricordarsi di usare una resistenza da ~320ohms per il secondo LED.
9 Resistenza = (Voltaggio_Arduino - Forward_voltage_LED) / (ampere utilizzati)
10 R = (5v-1.8v) / 0.010a
14 Schema: http://lab.piffa.net/schemi/led_single_bb.png
15 - http://lab.piffa.net/schemi/led_single_schem.png
17 This example code is in the public domain.
20 // Pin 13 has an LED connected on most Arduino boards.
23 int red = 12; // Definiamo un altro led
24 int breve = 200; // Variabile richiambile nel corso dell'esecuzione
27 // the setup routine runs once when you press reset:
29 // initialize the digital pin as an output.
30 pinMode(led, OUTPUT); // Abilitaiamo entrambi i LED
34 // the loop routine runs over and over again forever:
36 digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
37 delay(breve); // wait for a second
38 digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
39 delay(breve); // wait for a second
41 digitalWrite(red, HIGH); // turn the LED on (HIGH is the voltage level)
42 delay(lunga); // wait for a second
43 digitalWrite(red, LOW); // turn the LED off by making the voltage LOW